Assembly manual sticker holder for Ducato

This guide explains how to easily install the custom logo holder on your Fiat Ducato.
The process is illustrated with a sequence of photos arranged in chronological order.
No modifications to the original front bumper are required, and there is no need to open the engine compartment.
The installation is simple, quick, and requires no special tools.

What You’ll Need:

• Logo holder
• 4 screws
• Phillips screwdriver
• 2 clamping (mounting) parts
• Custom sticker of your choice (not included)

Installation Steps:

1. Step 1 – Preparation:
   Prepare all parts. We recommend working on a clean surface to avoid damaging the plastic components.
2. Step 2 – Attach the clamping parts:
   Lightly screw both clamping pieces to the right side of the holder using two screws.
   Tighten them only slightly – they should move freely to allow easy insertion under the original logo.
3. Step 3 – Insert the holder:
   Slide the prepared holder from the side so that the clamping parts fit under the original logo.
   Push the holder all the way in. Be careful – do not use excessive force to avoid pulling the screws out of their threads.
4. Step 4 – Fix and tighten:
   Use the remaining two screws to fasten the holder to the front grille.
   Then gently tighten all four screws – with care!
   The threads are plastic, so they hold securely by friction; over-tightening could cause bending or thread damage.
5. Step 5 – Final touch:
   After installation, you can attach any sticker to the front – for example, your company logo, bodybuilder brand, or personal design.

Quick installation – no need to remove the original logo.
The entire process takes approximately 10–15 minutes, including preparation.